Fender blues junior dating Mexican phone chat

Fender 8 ft POWER CORD, 3-WIRE, 18ga, SJT type, .250 TAB ends.

Black and White wires terminated in 1/4 inch push on terminals.

Longer cord for the Fender Vibrosonic, Custom Vibrolux, Ultimate Chorus, Rumble Bass, Hot Rod Deluxe, Hot Rod Deville, Blues Deluxe, Blues Deville, Blues Junior, Acoustasonic SFX, 65 Twin Reverb Reissue, 65 Deluxe Reverb Reissue, BXR200, 57 Twin Amp Reissue Standard NEMA 5-15 plug for North American use at 110-120 Volts AC. Clamp is 3/8" diameter, comes with 3/4" screw for mounting. Popular strain relief found on most vintage guitar amplifiers with round power cords, including most vintage Fender amps. Click here for specific dimensions of chassis hole. 9 pin ceramic PC mount socket, stand-off mounting, 3/4" diameter, 3/4" tail diameter. This 5-pack replaces all 5 tube sockets in the Fender Blues Junior. For bottom mounting (mounted from the inside of the chassis, below the chassis hole). Strat, Stratocaster, Esquire, Telecaster, Tele, Jazzmaster, Jaguar, Mustang, P. Bass and Fender are registered trademarks of Fender Musical Instruments.Green wire terminated in screw terminal for ground connection to chassis.Cord length 8 feet, cord thickness is 0.29 inches (about 9/32" or 7.3mm). The power cord as used in North America only on the Blues Junior.handle strap, made of simulated leather, replacement for Fender "tweed" style amps or vintage Ampeg amps (as well as other vintage amps. Remove amp chassis, drill new holes with 3/16" or 5mm drill bit, tap in T-Nuts on the underside and mount the handle. Black amplifier handle with vinyl sleeve over steel strap and one-screw mounting nickel-plated end caps. SPEAKER BAFFLE MOUNTING COPPER SCREW AND STAINLESS STEEL KEPS NUT FOR Fender TWEED AMPS.Has slight "raised" bump near the center of the handle. Fits Fender "tweed" style amps and some vintage Ampeg amps. Includes mounting hardware (two screws and T-nuts). Individual screw, copper 6-32, 1 1/2 inches long, Phillips and matching 6-32 Keps Nut with integral washer. Sets of either 4 or 5 screws, stainless steel 6-32, 1 1/2 inches long, flat stainless washers, Phillips and matching 6-32 Keps Nuts with integral washers.

Leave a Reply